Bowe, Bell + Howell 1200 - Manual (Page 5)

Hardware Setup & Installation
S006970 Rev B Page 1 of 14
Hardware Setup & Installation
CAUTION :
• Use only the power cord that is supplied by the manufacturer.
• Use the USB interface cable (supplied) that is certified as Hi-Speed by USB-IF.
• Do not connect the scanner to a USB hub. It is not guaranteed to work.
• Power
Requirements: AC outlet
AC 100 – 120 V, 50/60 Hz
AC 220 – 240 V, 50/60 Hz
Plug in the scanner’s supplied power cord and
USB cord into the back of the scanner.
Connect the power cord to an appropriate wall
outlet.
Connect the supplied USB cord to an available USB 2.0 port on the scanner’s host PC.
Turn on the scanner.
• Press the power switch. With power applied,
the LED will light.
1
2
3
4