JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual - Manual (Page 39)

39
7 Setup program
USB/TTL
Figure 14: Establishing the connection between PC and probe
via the USB/TTL converter and adapter socket
For the setup via the USB/TTL converter, establish the following connections:
How to proceed:
1 Laptop/PC 5 Modular jack RJ-45
2 USB connector 6 Adapter of the modular cable
3 USB socket 7 Adapter socket, 4-pin
4 USB/TTL converter 8 Probe interface
Step Activity
1 Insert the USB plug of the USB cable (2) into the laptop/PC (1).
2 Open probe.
 Kapitel 3.1 "Fitting/exchanging the battery", Seite 19
3 Insert the USB bush of the USB cable (3) into the plug of the USB/TTL converter (4).
4 Insert the modular jack RJ-45 (5) of the modular cable into the bush RJ-45
of the USB/TTL converter (4).
5 Connect the 4-pin adapter bush (7) to the adapter of the modular cable (6).
6 Connect the adapter socket, 4-pin, (7) to the probe interface (8).