BOB MA0270 - Manual (Page 3)

clockwise direction.
To set the parking
brake, squeeze the
brake lever and
press and hold the
button down, then
release lever (Fig.
13 &14). When the
brake is properly set,
the button will
remain depressed
and the lever will
appear as shown in
Fig. 14. To release
the parking brake,
simply squeeze the
brake lever and the
button will “pop” up.
For the parking
brake to work
correctly, it is critical
that the brake be
adjusted properly.
Squeeze the brake
lever and verify that
the brake pads contact the rim as shown in Fig. 16. If they are
misaligned, use a 10mm wrench to loosen brake pad nuts, slide pads
into correct position and tighten securely. The cable tension is pre-
adjusted at the
factory yet the brake
cable will need
periodic adjustment
(as the cable
stretches slightly
and the black cable
housing
compresses over
time). To adjust
cable tension, there
are two barrel
adjusters in the
brake assembly
(Fig. 10 &13). To tighten the cable, loosen the lock ring and turn the
barrel adjuster in the counter clockwise direction. Secure the barrel
adjuster in the new position by tightening the lock ring against the
caliper or brake lever body. There should be a 3/16” clearance between
the rim and brake pads as shown in Fig. 15. If gap is not equal on
each brake pad, you can reposition the brake on the frame by
loosening the 10 mm nut (Fig. 16) with a 10mm wrench, adjust to the
gap shown in Fig. 15 and retighten the same nut. If you do not
understand these instructions, or feel the brake is adjusted incorrectly,
take the stroller to your dealer for proper adjustment. If your brake
pads (Fig. 10) are worn, see your dealer for replacements.
AFOD: With the stroller in the opened position, attach the AFOD
(Anti-Fly-Out-Device)
around the cross tube with
the plastic buckle (Fig. 17).
It is important that the AFOD
is always properly secured
when using the stroller, as
it is part of the child’s seat
restraint system. It is,
however, necessary to
release the AFOD in order
to fold the stroller.
SUN CANOPY: The Duallie
features a two position
canopy. To fully open the
canopy, rotate the assembly
forward until the fabric is
taut. The rear safari flap should
be freed from the Velcro to give
additional sun protection. To
reduce the size of the sun canopy,
pull the canopy toward the
handlebar. The additional fabric
can be gathered by pulling the
canopy (Fig. 1) drawstring and
securing the cord lock.
SEAT TENSIONING: The seat
compartments are divided by a
section of nylon webbing that runs
the length of the stroller. From
time to time it may be necessary
to increase the tension of the
webbing. To adjust the tension
start with handlebar in the fully
open position as shown in Fig 3.
At the top of the seat the webbing
loops over the handlebar cross
tube and connects to a ladderlock.
At the bottom of the ladderlock
there is a tensioning strap. Pull
on this strap to increase the
tension.
SEAT SAFETY HARNESS: To
secure your child in the seat, put
one strap (grey) over each
shoulder and snap the male buckle
into the female receiver on the
crotch strap (Fig. 18). Adjust
shoulder straps to be snug and
secure (Fig. 19). Connect and
adjust the sternum strap (red), see
Fig. 20.
WARNING: Never place
passengers in the stroller without
securing them in the harness.
Unrestrained passengers can
affect the control of the stroller.
Total Passenger Weight Limit -
100 Pounds (45 Kilograms)
RECLINING SEAT: Set parking
brake before making any seat
adjustments. To recline the seat,
rotate the ladder locks (Fig. 21)
forward thus releasing the reclining
straps. To raise the seat, pull the reclining straps until you obtain the
desired position. The seat back can be adjusted to recline anywhere
between the fully upright position and the fully reclined position (Fig.
21 & 22).
SHOCK ABSORBERS: The
suspension system features two
shock positions to provide a
comfortable ride for kids of
different weights. The two
positions are shown in
Fig. 2. Position 1 is
intended for occupants
up to 50 lbs. ( 22.5 kg),
while position 2 is
intended for occupants
from 50 to 100 lbs. (22.5
to 45 kg) total. The Duallie
features a sliding track and
spring loaded shock axle that
automatically locks in place when it aligns with either of the two shock
settings. Shock position adjustments should be made with the stroller
unloaded. The Duallie will lock into position 1 when unfolding the
DUALLIE OWNER’S MANUAL
9
12
10
11
Fig. 15 3/16” clearance between brake pad & rim
Tire
3/16”
Rim
Brake
Body
Brake
Pad
Fig.16 Brake pads shown aligned to rim
10mm Nut
Fig. 17 AFOD correctly attached
AFOD
Cross Tube
Wrist Strap
Fig. 18 Place straps over shoulders
and secure to buckle.
Shoulder
Strap
Fastener
Shoulder
Strap
Fig. 20 Connect Sternum Strap
Sternum
Strap
8
13
Fig. 23
Stroller with handle folded
Fig. 19 Securely adjust shoulder straps
Fig. 22 Seat in fully reclined position.
Reclining
Strap Loops
Fig. 21
Seat Reclining
Ladder Locks
Brake Pad
Nut