BOB MA0270 - Manual (Page 4)

stroller. To use the stiffer shock
position, move the shock from
position 1 to position 2 by
depressing the shock release
button (Fig. 2) with one hand, and
with the other hand, lift slightly
and pull the shock backward.
When the shock axle is
properly aligned in position
2, the axle will “snap” into
place. Repeat this process for
the second shock. To move the
shock from position 2 to position
1, reverse the above process for
both shocks.
FOLDING: Remove children from stroller. Remove the contents of
the Low Boy cargo pouch. Unbuckle the AFOD strap
(Fig. 17). The shock absorbers must be in
position 1 (Fig. 2) before folding. Press
both the right and left handlebar
release levers (Fig. 3), and fold
the handlebar forward as
shown in Fig. 23. Locate
the frame release handle
underneath the seat (Fig.
24) and pull upwards
sharply. This will allow the
lower frame to fold together,
as shown in Fig. 25. The
folded stroller can be made
even more compact by
removing the front and
rear wheels. The front
wheel is removed by
opening the brake quick
release (Fig. 10),
opening the wheel quick
release and removing
the wheel (see section
6). Note that it is often
easier to open the brake
quick release before you
fold the handlebar. The
rear wheels are removed
by opening the rear
wheel quick release (Fig. 4), and removing the wheels.
The Wrist Strap can be used to keep the stroller in the folded position
for transport and storage. With the stroller folded, loop the end of the
wrist strap around the handlebar and back to the cross tube and fix
the Velcro surfaces together (Fig. 26).
TIRE PRESSURE: IMPORTANT: Inflation pressure must always fall
within the range embossed on the sidewall of the tire (usually 25-35
p.s.i.)
STROLLER CARE and MAINTENANCE :The fabric is 100% polyester
with a stain resistant treatment that makes cleanup easy. Use a sponge
with a solution of mild soap and lukewarm water (maximum temperature
of 100 degree Fahrenheit). Rinse thoroughly with clean water to
remove soap then air dry. Do not use detergent.
Regular maintenance should include: Verifying tire pressure, verifying
that all screws and fasteners are tight, and wiping parts clean with a
rag. To reduce the possibility of squeaks, periodically apply a small
amount of lubricant (Triflow, 3-in-one, or light sewing machine oil) to
the frame pivot axle and interior faces of the pivot bracket, as shown
in figure 27.
STORAGE: It is best to store your stroller indoors when it is not in
use. This will prolong its attractive appearance. Extended exposure
to the sun's ultraviolet rays can fade and damage the fabric, tires,
and plastic parts.
CARGO: The Duallie
is equipped with four
small pockets for the
kids, a seatback pocket
and a Low Boy cargo
pouch under the stroller.
Adding weight to the
seatback changes the
center of gravity of the
stroller, and increases
the possibility that it will
tip over backwards. For
this reason, loads in the
seatback pocket should
never exceed two
pounds (1 kg.). Although
the seatback is padded, it is
important to remember that this
is what your child leans against.
Never place sharp or injurious objects into the
seatback pocket.
LIMITED WARRANTY
BOB Trailers Inc. takes pride in its workmanship and strives to
manufacture the best products possible. Therefore, we warranty our
Duallies against defects in material and workmanship subject to the
conditions listed below. Since no product is indestructible, it does not
cover defects attributable to or resulting from normal wear, abuse or
alteration.
Frame is warranted for 5 years.
Components and fabric are warranted for one year.
Warranty is only valid for the original purchaser.
Proof of purchase is required to exercise this warranty.
Labor and freight charges are not included.
Normal wear, neglect, abuse, accidents, improper assembly or
maintenance, or the installation of parts or accessories not compatible
with the original intended use of the stroller, as sold, are not covered
by this Warranty.
Warranty claims must be made through an authorized dealer.
This warranty is limited to the repair or replacement of the defective
part. BOB shall in no event be responsible for consequential or
special damages.
This Limited Warranty is the only express or implied warranty
applicable to BOB. Any implied warranties, including warranties
of merchantability and fitness shall be limited in scope and duration
in accordance with this limited warranty.
STROLLER ACCESSORIES
Also available for Duallie Models
(800) 893-2447 www.bobgear.com email- [email protected]
Phone: (805) 541-2554 Fax: (805) 543-8464, 3641 Sacramento Dr. #3 San Luis Obispo, California 93401
15
Your little one will be
dry & comfortable in bad
weather, strolling with the
BOB Weather Shield!..
Warm Fuzzy Seat Insert -
The ultimate in plushness
& comfort. Thick,
polypropylene fleece
will give you and
your child a warm fuzzy!
(Two required for Duallie)
Fig. 27
Pivot Axle Lubrication
Apply Lubricant
to Axle
Apply Lubricant
to Interior Faces
of Bracket
Fig. 25
Stroller in fully folded position
14
AFOD
Unbuckled
Frame
Release Handle
Fig. 24
Pull handle upwards sharply to fold
Wrist Strap
Handlebar
Velcro
Cross Tube
Fig. 26 Secure stroller in folded position
MA0270