KD Scientific Adagio Control Software for Legato Series Manual - Manual (Page 10)

Adagio User Manual © 2010 KD Scientific
5619-001 Rev B
10
Note that if you close and restart Adagio, pumps connected via
a USB cable may re-establish communication through a
different COM port than was previously defined. Therefore, if
multiple pumps are defined they could potentially change
COM ports during a re-start. Be sure to verify which pump you
are communicating with before running a Method.
Except for “ green ” status, the row color (text foreground color) coincides
with the status icon color in order to facilitate its visual identification.
• Pump Name: shows the name assigned to the pump during its
definition.
• Pump Model: shows the name of the pump model detected by the
software.
• Serial Number: shows the serial number of the pump entered during
its definition.
• Communication: shows the communications port name (COM port)
and the address of the pump entered during its definition in the
following format :
<COM port name> [<Pump address>]
By default, table rows are sorted by connection, that is, by COM port and
address. Sorting can be changed by clicking on the column headers of the
table.
The Pump Configuration window includes a toolbar with the following
buttons:
• Add New: Launches the Pump Configuration Assistant tool in
order to define a new pump. This button is enabled only if the total
quantity of defined pumps has not reached the limit.
• Edit: Launches the Pump Configuration Assistant tool in order to
modify a previously defined pump. This button is enabled when one
(and only one) pump is selected.
• Delete: Asks you to confirm whether to remove the selected pump(s).
This button is enabled when at least one pump is selected. See “3.2.
Removing pumps from the system” for more details.