Koolance AMD 64 Adapter - Manual

The AMD 64 Adapter is designed for AMD
Athlon 64, FX, and Opteron processors
in socket 754, 940, and 939 formats. The
motherboard may need to be removed from
the chassis in order to install this device.
AMD 64 Adapter Installation v 1.0
Various hardware comes with the Koolance
AMD 64 Kit, and depending on your particular
motherboard, some of it may not be required.
AMD 64-bit boards have 2 primary mounting
holes which the Adapter will use.
1 2
Bracket
Clips
Plastic Spacers
Nuts
Long
Screws
Short Screws
Remove the black plastic
retention frame from the
motherboard. Generally,
this is held in place with 2
metal screws.
(If there are plastic tabs
instead of screws, please
refer to the next section.)
Turn the motherboard over and push the center locking
bolt inward with a small fl at screw driver.
Finally, squeeze the remaining tabs together beneath
the board, and gently push them through with long-
nose pliers.
This should allow you to remove the CPU socket’s
black plastic rentention frame from the motherboard.
From the top side, pull up both plastic center locking
bolts.
For motherboards with plastic tabs instead of metal
screws, please follow the instructions on this page.
Otherwise, skip to the next section.