Koolance ERM-2K3UCU - Manual (Page 9)

10 11 User Manual Connecting ERM Systems
Connecting the Slot Adapter
The Slot Adapter allows the ERM to connect with any ATX computer through an
available card slot. It is responsible for both input and output tubes, along with the
temperature sensors and ATX shutdown signal wire. This prevents the computer
chassis from requiring any modifications for the cooling unit.
NOTE: The slot adapter’s tubing holes will accommodate an outside diameter up
to 13mm (3/8”). For larger tubing, please consider an optional Koolance PCI G 1/4”
Socket L-Bracket. This allows the use of larger diameter nozzles.
There are 4 main internal connections to the Slot Interface card which will be
made. The ERM may appear to operate without some of these connections, but
hardware safety features or temperature monitoring might be deactivated.
Start by connecting Temperature Sensors #1, #2, and #3. Then connect the ATX
Pass-Through wire.
ATX Power
Switch
Pass-Through
Temperature
Sensor #1
Temperature
Sensor #2
Temperature
Sensor #3
Optional Fan
Headers
Install the Slot Adapter into any available rear
card slot in your computer.
Screw the Slot Adapter in place as you would
a normal device.
From the rear of the case, carefully feed
both ends of the liquid tubing through the
Slot Adapter and into the chassis.
Plug the other end of the ERM’s external
power cable into the Slot Adapter.
Installing the Slot Adapter