Koolance PSU-1000ATX-12N-R - Manual (Page 2)

If shutting-down the power supply
using the rear illuminated power
switch, it may become necessary
to reset the unit before it can be
powered-up again.
To do this, turn the AC power
switch to the “Off” position. Then,
unplug the main AC power cable from the PSU-1000ATX-12N. Wait
approximately 20-30 seconds until the green “DC” indicator light stops
blinking. Then reconnect the AC cable and move the power switch to the
“On” position.
DO NOT ATTEMPT TO OPEN THE BOTTOM NOZZLE SOCKETS!
Doing so will release the internal coolant and void the product warranty.
DC indicator light AC Power Switch
Protective Nozzle Inserts (Remove)
Your Koolance PSU-1000ATX-12N power supply may arrive with
rubber inserts to protect the top nozzle connections during shipping.
These should be removed before inserting your desired nozzles.