Kuryakyn 4082 ERGO III ADJUSTABLE CRUISE MOUNTS WITH PREMIUM MINI BOARDS - Manual (Page 4)

-cont.-
PAGE
4
STEP 12 Determine the left footpeg clevis from the right. PIC 10 When installed, the left clevis will have its
footpeg stop on the top side and the screw hole will face the rear of the bike. PIC 10
STEP 13 Apply some Blue Loctite (248) to one of the 3/8”-16 X 1” Socket Head Cap Screws. Install the
clutch-side footpeg clevis on the Extension Arm. Secure it with one of the 3/8” Screws. Leave the
screw loose until the clevis has been adjusted.
STEP 14
Push down on the Rotating Arm until it reaches its stop; adjust the angle of the clevis so the foot-
peg will fold up and back at an angle. Ensure the splines on the clevis and arm engage and tighten
the screw. Torque the screw to 20 FT/LBS.
FOOTPEG INSTALLATION:
NOTE: Even though the picture below shows a different footpeg than the one included in this kit,
the installation of the Premium Mini Board is the same.
STEP 15 Apply some Blue Loctite (248) to the 5/16”-18 X 1” footpeg screw threads. Install the clutch-side
footpeg in the clevis and secure it with the 5/16” footpeg screw. PIC 11 If necessary, use the in-
cluded Wave Washers to take up any excess space between the footpeg adapter and the clevis.
Torque the screw to 25 FT/LBS.
STEP 16 There are three splined mounting holes in the Mini Board. You
may use these holes to position the Board forward or rearward,
angled up or down. To adjust the Mini Board, remove the 5/16”-
18 socket head cap screw and washer from the Mini Board. This
will leave the adapter in the clevis. Choose the position of the
Mini Board, then insert the 5/16”-18 socket head cap screw, with
flat washer, through the Mini Board and thread it into the mount.
Ensure the splines are engaged, then tighten the screw securely.
STEP 17 Repeat STEPS 9 through 16 for the other side.
ERGO III ADJUSTABLE CRUISE MOUNTS WITH MINI BOARDS INSTALLATION
PIC 11
USE A WAVE WASHER TO
TAKE UP EXCESS SPACE
NOTE: Place a drop of Loctite Threadlocker Blue 248 on
the threads of the clevis and footpeg screws before
installing. Follow the manufacturer’s recommenda-
tions for proper application.
FAILURE TO ADJUST FOOTPEGS SO THEY FOLD UPWARD AND
REARWARD IF CONTACTED BY ANY OBJECT COULD RESULT IN
LOSS OF CONTROL THAT COULD RESULT IN SERIOUS INJURY OR
DEATH.
PIC 10
CLUTCH-SIDE (LEFT) BRAKE-SIDE (RIGHT)
FRONT OF
BIKE
FRONT OF
BIKE
ENSURE FOOTPEG STOP IS ON THE TOP WHEN INSTALLED