Kuryakyn 3232 L.E.D. SADDLEBAG ACCENT SWOOPS - Manual (Page 2)

PAGE
2
STEP 2
Remove the saddlebag doors from the saddlebags by removing the four hex head fasteners from
the hinges and disconnecting the slave and tether from the door. PIC 2
and PIC 3 Set this hardware aside, it will be reused.
Assistance is recommended in holding the door before all of
the fasteners have been removed to prevent the door from
falling and being damaged.
STEP 3
Remove the three fasteners from the locations shown in PIC 4 on the
back side of each saddlebag door. Set these aside, they will not be
reused.
STEP 4 Using a 1/8” drill bit, carefully drill STRAIGHT through each location that
the fasteners were removed from in Step 3. Drill from the back side to
the front. Gradually increase the size of the drill bit to 1/4” making sure
the hole remains STRAIGHT through the door.
NOTE: Drill slowly using light pressure, the doors are plastic and will
drill easily.
Ensure the hole remains straight through the door. Kuryakyn
will not be responsible for incidental or consequential
damages resulting from this installation.
STEP 5
Using the included #6 screws and washers, fasten the Side Accents to
each door loosely. (Make sure to use the washers under the head
of each screw. Leave the screws loose to ease installation of the
Accent Extensions in the following Steps) Use the
#6 x 1-3/8” (longer) in the two rearward holes, the #6 x 1-1/8” (shorter)
in the front hole on each door.
STEP 6 Install the doors back on the saddlebags using the hardware removed in
Step 2.
Ensure the area of installation is free of grease, oil, dirt or
other debris including wax/polish products and bugs to
ensure proper adhesion. Küryakyn WILL NOT issue a
warranty on any parts lost due to improper installation.
STEP 7 Thoroughly clean the front black portion of the saddlebag door (PIC 5)
with soapy water and a clean rag. Dry completely. Wipe the area with the
included alcohol pad to remove any residue.
NOTE: Use the Accent Extensions as guides to make sure you clean
enough of the saddlebags.
STEP 8
Test fit the Black Extension to the
front of the saddlebag door. The top
edge of the Extension will follow the
line between the painted portion of
the door and the black portion. Make
any reference marks with masking
tape or a non-permanent marker.
The adhesive will not bond
correctly if applied at
temperatures less than
50°F. Do not attempt this
installation in temperatures
less than 50°F.
SADDLEBAG ACCENT SWOOPS
INSTALLATION
-cont.-
PIC 2
PIC 3
REMOVE THESE FASTENERS
PIC 4
REMOVE THESE THREE FASTENERS
AND DRILL THE HOLES THROUGH.
PIC 1
REMOVE THESE FROM BOTH DOORS