Kuryakyn 3232 L.E.D. SADDLEBAG ACCENT SWOOPS - Manual (Page 3)

PAGE
3
STEP 9
Rub the backing on the Accent Extension with your fingernail to activate the adhesive. Peel the
backing off the Accent Extension.
STEP 10 Slide the rear of the Accent Extension under the front of the Swoop
assembly and, moving back to front and following any reference marks
made in Step 8, press the Accent Extension firmly in place for one
minute. PIC 6 Full bond strength will occur in 24 hours. Repeat Steps 7,
8, 9 and 10 for the other door.
STEP 11
Make sure the wire harness from the Swoop is in the notch on the bottom
of the Swoop and there is a washer under the head of each screw
installed in Step 5. tighten the fasteners from Step 5 snugly. DO NOT
over tighten these, they may crack the screw boss in the Swoop
assembly or push through and create dimples in the outer black.
Küryakyn will not issue a warranty for any part that show
signs of over-tightening.
STEP 12
Use the included cable ties to secure the wire harness to the saddlebag
brace on each side of motorcycle. PIC 7 Make sure that the wire
harnesses are as far from the exhaust as possible.
Secure all wiring away from any moving parts, pinch points
or extreme heat. Küryakyn WILL NOT issue a warranty on
any electrical component that fails due to pinched, crimped,
broken, abraded, melted or frayed wires.
STEP 13
Remove the rear fender panel from the motorcycle by removing the four
fasteners. PIC 8
Küryakyn recommends the use of dielectric grease on
electrical connections.
STEP 14 If you have an open six pin connector on the Plug and Play Harness,
(previously purchased and installed), connect the six pin connector from
the Triple “Y” harness to it. If you do not have an open connector,
disconnect one of the six pin sets and connect the included Triple “Y”
connector in line. Connect the existing accessory and the Accent Lights to
the new Triple “Y” connector. Use the included cable ties to secure the
harness out of harms way.
NOTE: It does not matter which connector from the Accents is plugged
into which Triple “Y” connector, the Accents are wired to draw
from the correct wires on each side.
STEP 15
Test all lights for the correct functions.
ENSURE PROPER LIGHT OPERATION BEFORE RIDING
THE MOTORCYCLE. VISIBILITY IS A MAJOR CONCERN
FOR MOTORCYCLISTS. A LIGHTING MALFUNCTION
COULD RESULT IN DEATH OR SERIOUS INJURY.
STEP 16 Replace the rear fender panel.
It is the installer’s responsibility to ensure that all of the
fasteners (including pre-assembled) are tightened before
operation of the motorcycle. Küryakyn will not provide
warranty coverage on products or components lost due to
improper installation or lack of maintenance. Periodic
inspection and maintenance are required on all fasteners.
Ride On!
SADDLEBAG ACCENT SWOOPS
INSTALLATION
PIC 5
THOROUGHLY CLEAN THIS AREA
SECURE TO THIS BRACE WITH CABLE TIE
PIC 7
REMOVE THESE SCREWS
PIC 8
PIC 6
SLIDE REAR OF ACCENT UNDER SWOOP
AND WORK TOWARDS FRONT OF DOOR