Bernina 8 SERIES V29.39.00 User Manual
Page 2
Information on Software Update
BERNINA 830 / 820
Software Version
3
1 General Changes
3
1.1 Language “Finnish” integrated
3
1.2 Display of data version number
3
2 Sewing Updates
4
2.1 Thread tension for the underlay segments (buttonholes)
4
2.2 Manual threading
5
2.3 The use of straight stitch feet with thread cutting
5
2.4 Disable automatic thread cutting when opening the bobbin door
5
2.5 Thread cutting without fabric movement
5
2.6 “Manual” winding of the lower bobbin thread
5
2.7 Winding indicator during sewing/embroidery
6
2.8 Reset of back stepping history
6
2.9 Thread breakage hint
7
2.10 Problem with Foot #57D and straight stitch plate compatibility
7
2.11 Presser Foot #0 can be used for automatic threading. With the “Walking foot”
automatic threading is not possible
8
2.12 Information Foot #2a corrected
8
2.13 Pattern #169 improved
9
2.14 Tension changed for the “tie on” stitches
9
2.15 Upper thread detection changed
9
3 Embroidery Updates (BERNINA 830 only)
10
3.1 Start of embroidery
10
3.2 Using zoom option with panning
10
3.3 Using Foot #44C (The new CutWork & Echo quilting foot)
10
3.4 Thread tension can be changed to a minimum of 0.5
11
3.5 Stop for manual cutting can be switched off
12
3.6 Manual “tie on” for embroidery
12
3.7 Delay of Start/Stop button reduced for embroidery
13
3.8 Thread breakage during jump stitches
13
3.9 Stitching “without thread”, shown now in embroidery mode
13
4 Important points
13
4.1 Hoop calibration
13
4.2 Feedback issues
13
4.3 Free memory
13
2/14, 04.11.2009