Kuryakyn 8827 FRONT SPLINED ADAPTER - Manual (Page 2)

InStALLAtIon
STEP 4 With the rivet drilled out, remove the pin and slide the peg out of the adapter.
None of the stock hardware will be reused.
STEP 5 Install the new Splined Peg Adapter with the provided hardware.
Refer to PIC. 3 for order of hardware.
STEP 6 When you have the adapter tight, you can set the height of the
peg by tightening or loosening the setscrew.
ATTENTION! It is the installer’s responsibility to ensure that all of the
fasteners (including pre-assembled) are tightened before
operation of the motorcycle. Küryakyn will not warranty
components lost due to improper installation. Periodic
maintenance may be required.
Ride On!
PAgE
2
f R o n t S P L I n E d A d A P t E R S
PIC. 2
PIC. 3
SoCkEt HEAd
CAP SCREw
nyLon InSERt
SEt SCREw
wAvE
wASHER
SPLINED
PEG
ADAPTER