KV2 Audio COMPEX - Manual (Page 9)

Page | 9
Connect the COMPEX between signal source directly after your mixing console and amplifier or active
speaker system. The COMPEX uses balanced XLR connectors with standard signal level 0dBu. Outputs
of the the COMPEX features line drivers to maintain audio signal integrity over long cable lengths.
Run the audio system at the desired level and set the compressor threshold level to reduce harshness
for comfortable listening.
Set the drive to create desired level of harmonics and mix with the original signal. The right mix of
harmonics will make the sound more open and clear. To compare the sound with the original source
or to deactivate the unit you can use the bypass switch. The unit is bypassed, when switched off.
Using the System
OUTPUT INPUT
R L R L REMOTE
BYPASS CONTROL
WWW.KV2AUDIO.COM
KV2 AUDIO, MANUFACTURED IN THE EUROPEAN UNION
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE
COVER OR ANY ATTACHED COMPONENTS. NO OPERATOR SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL ONLY. TO REDUCE
THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
SERIAL NUMBER
230 VAC, 50/60 Hz
MAX 6WATTS
L-Full Range
In
R-Full Range
In
L - Full Range PA R - Full Range PA
COMPEX wiring example