Landoll SL 8, 10, 12 Turfmaker Seeder - Manual (Page 30)

2-20 1P342
ASSEMBLY INSTRUCTIONS
3. Mount the other two coil tines to the bar with the 3/8”
x 3” capscrews, lockwashers, and nuts which also
attach the arm weldments to the bar.
4. Clamp the brackets loosely to the seeder frame, with
u-bolts, lockwashers, and nuts.
5. Attach the adjusting angles to frame brackets with
lockscrews. Secure the adjusting angle from
swinging with a 1/2” clevis pin and hair pin cotter.
6. Fasten the bar and tine assemblies to the adjusting
angles with 1/2” x 1-3/4” capscrews and locknuts.
Tighten the locknuts to allow the free side to side
swing.
7. Center the entire wheel track leveler behind the
tractor tires. Tighten the u-bolts against the seeder
frame. See Figure 2-21.
8. Attach the chains’ end links to the adjusting angles
with 3/8” x 1-1/4” capscrews, flat washers,
lockwashers and nuts. There is one chain for the left
side and one chain for the right side.
The vertical position can be changed by removing the
clevis pins and lock screws and moving the adjusting
angles up or down.
To inactivate the tines, remove the 1/2” clevis pins and
loosen the lock screws. Then swing the bar and tine
assemblies upward and sideways. To hold in place, wrap
the chain under the bar and place the chain into the slot
in the adjusting angle. Re-tighten the lock screws.
Figure 2-21: Coil Tine Setup
Bar & Tine Assembly
Wrap the chain under
the bar and place
the chain into the slot.
Clevis Pin, 1/2”
Lock Screws