Landoll SL 8, 10, 12 Turfmaker Seeder - Manual (Page 43)

OPERATION
3-11
Electric Clutch Kit - Optional
If an electric clutch has been installed on your seeder:
The clutch is controlled by a toggle switch mounted to the
tractor by a “Velcro” type hook and loop fastener.
Clutch characteristics are as follows:
• Clutch is disengaged when power (12 volts) is applied.
If there is a power failure or electrical problem, the
seeder will continue to operate, and machine must be
raised to stop seeding.
• Seed shafts will not rotate when machine is backed
up.
• Switch box contains a standard 5 amp fuse.
• Clutch must be disengaged (power applied) when
seed shafts are turned manually for calibration.
Figure 3-10: Electric Clutch
1. Check that clutch case has proper
clearance between rubber bumper stop.
Improper clearance may prevent the clutch from
engaging or disengaging
Secure to frame and drawbar or with hydraulic
hoses and warning light harness by cable ties
or adhesive mounts.
2. Connect clutch wiring harness
to clutch lead, and route wire
along frame and drawbar.
Clutch Lead
Clutch
Clutch Wiring Harness
1/8” GAP
Clearance from
Bumper Stop
Clutch
Bumper Bolt
Adhesive Mount
Clutch Wiring
Harness
Warning Light Harness
Hoses &
Hose Clamps
Cable tie