Landoll WFPC22-36 Wing Float Pulverizer - Manual (Page 15)

2-1
Chapter 2
Assembly
This chapter covers proper assembly of your implement.
The reference numbers on the following pages give you
an indication of assembly order. Refer to the Wing Float
Pulverizer Parts Manual F-702 for complete part
breakdowns and proper location of any parts not shown
in the following illustrations.
NOTE
The machine shown in the following illustrations may not
agree with the size of your unit. Assembly of machines,
however, is similar on all models. Additional parts
identification and location can be obtained by reviewing
the parts manual.

WARNING
IMPORTANT
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
the parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
• Refer to the Torque Table for proper bolt torque
values. Note the different torque requirement for bolts
with lock nuts. See Page 4-1.
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means.