Leica Biosystems IPS (Supplement) - Manual (Page 8)

8 2013-01 Supplemental sheet for IP C and IP S V 1.1 RevB – 09/2013
Fig. 3
5
Removing the red protective cap
• Unscrew the red protective cap all the way, remove
the information flag and place the red protective cap
in the recess provided on the ink cartridge (6, Fig. 8 ).
• Upon completion, make sure that the red retaining
bracket is in the correct position (8, Fig. 8 ) and close
the door on the printer.
Inserting the new ink cartridge (continued)
Puncturing the cartridge seal requires that
some force be applied. Withdraw the ink car-
tridge about 30 mm from the slot and push it
back in as far as it will go; repeat this step two
or three times (5, Fig. 3 ).
Follow the information on the flag attached to
the ink cartridge ( see Fig. below ).
• Open the red protective cap (4, Fig. 2 ) one turn coun-
terclockwise.
• Then fully insert the ink cartridge into the slot.
Informational flag
Fig. 8
6 8
Supplemental sheet for instructions for use for IP C and IP S V1.9 RevD - 05/2013
• For the procedure, see Instructions for Use Chap. 6.2
and Chap. 6.2 .
Fig. 9
Fig. 10
Removing the location plate
• For the procedure ( Fig. 9 ), see Instructions for Use,
Chap. 6.2 .
Manually cleaning the print head
• For the procedure ( Fig. 10 ), see Instructions for Use,
Chap. 6.2 .
Inserting the location plate
Never press the CLEAN button while a new or
used ink cartridge is in the instrument!