Service – Bunn TNTF-3 User Manual
Page 14
Page 14
SERVICE
This section provides procedures for testing and
replacing various major components used in this
brewer should service become necessary. Refer to
Troubleshooting
for assistance in determining the
cause of any problem.
WARNING - Inspection, testing, and repair of electri-
cal equipment should be performed only by qualified
service personnel. The brewer should be disconnected
from the power source when servicing, except when
electrical tests are required and the test procedure spe-
cifically states to plug in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power
source before the removal of any panel or the replace-
ment of any component.
All components are accessible by the removal of
the top cover and rear inspection panel.
The top cover is attached with four #6-32 screws.
Removal of the top cover will allow access to ICED/
OFF/HOT switch, start switch, brew timers, control
thermostat, limit thermostat, thermal fuse and tank
heater.
The rear inspection panel is attached with six #8-
32 screws. Removal of the rear panel will allow access
to the brew solenoid valves and the dilution solenoid
valve .222 GPM flow control and check valve.
Contents
Brew Solenoid Valve (Hot Tea) ............................ 15
Brew Solenoid Valve (Iced Tea) .......................... 16
Brew Timer (Hot Tea) (Early Models) .................. 17
Digital Brew Timer (Hot Tea )(Late Models) ........ 18
Brew Timer (Iced Tea) (Early Models) ................. 20
Digital Brew Timer (Iced Tea)(Late Models ......... 21
Control Thermostat ............................................. 23
Dilution Solenoid Valve ....................................... 24
Limit Thermostat ................................................ 25
ICED/OFF/HOT Switch ......................................... 26
Start Switch ........................................................ 27
Tank Heater ......................................................... 28
Thermal Fuse ...................................................... 29
Wiring Diagrams ................................................. 30
FIG. 1 COMPONENT ACCESS
P1370.40
28201 081500