Lenze IPC Operating System Windows Embedded Standard 2009 - Manual (Page 9)

Getting started
Default settings
2
l
9 SHPWES EN 1.0
2 Getting started
2.1 Default settings
For all Windows Embedded Standard 2009 images, two users and a permanent IP address
are defined. The default settings are as follows:
Default user Default password Rights
Administrator admin Administratior
MyUser (no password) User
Observe case sensitivity when writing your password!
Settings for the first network connection:
IP address: 192.168.5.99
Subnet mask: 255.255.255.0
Default gateway: 192.168.5.1
This is required both for an automated system login and for a remote desktop connection.
2.2 Change user settings and create more users
Go to the user management of the system control to change the settings (password,
account type etc.) for existing users and to create new users.
)
Note!
If you assign a password to a user with restricted access rights, please ensure
that the "Password does not expire" flag is set.
This is important, in particular, because limited access rights for system
partition C:\ entail full write protection by default which makes it impossible
to write a new password to the system partition. The password may be
accepted but is only saved volatilely to the RAM and will be gone when the
system is restarted.
Please follow the path below to check if the "Password does not expire"
control field has been selected:
Right−click My computer
à "Manage" à "Local users and groups" à "Users"
à<User name> à"General" register