Lightforce LED 180 User Manual
Page 3
LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © June 2014 • Data and specifications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification.
The LED 180 has additional mounting points on each side and top of the housing.
The side mounting points have a captive M6 and M8 nut with the top mounting point. A M5 x 0.8 thread 10mm in depth this
point is suitable for attaching a stay bar for increased stability.
REMOVING AND REFITTING THE FILTER:
Filter Removal
• Insert coin at bottom of light between filter tab and bezel
• Twist coin and using the tab pull filter away from bezel
Refitting
• Insert the filter at the top position
• Push filter onto bezel using filter tab at bottom until side clips are engaged
• Ensure filter is correctly aligned within bezel
CAUTION
When handling the filter, take care of the surface as this can mark easily (for cleaning see ‘General Care and Safety Tips’ sec-
tion).
TECHNICAL SPECIFICATIONS:
•
70W (7 x 10w CREE chipsets)
•
Input voltage range: 10-36V DC
•
Current draw: 4.8A @ 13.2v
•
Colour temperature: 5000K
•
50,000+ Hour LED lifespan
•
Input cable 450mm (17.72”)
•
Operating temperature -40°C to 63°C (-40°F to 145°F)
•
Dimensions 181mm (W) x 196mm (H) x 97mm (D) (7.12“(W) x 7.72” (H) x 3.82”(D))
•
Weight 2.1kg (4.6lb)
•
Top mounting point thread M5 x 0.8 depth 10mm (0.39”)
RECOMMENDED WIRE SIZE:
2.0mm2 (14AWG) MINIMUM
MOUNTING FASTENER TORQUE SPECIFICATIONS
M10 x 30mm bottom mount bolt - 35Nm (26lb-ft)
M10 x 30mm cross-bolt - 35Nm (26lb-ft)
WARNING:
The bolts that retain the mount to the light cannot exceed 35mm in length otherwise damage to the housing can occur.