Loadstar Sensors DI-1000U Digital Load Cell Interface Manual - Manual (Page 2)

DI-1000 Di1000 User Guide
Page: 2 / 25
P/N : 033-01591 Rev. 6
Notes
© Copyright 2008/2014 Loadstarsensors Inc. All Rights Reserved.
No part of this manual may be reproduced in any form or by any means (including electronic storage
and retrieval, or translation into a foreign language) without prior agreement and written consent from
Loadstarsensors, Inc. as governed by United States and international copyright laws.
Manual Part Number
033-01591
First Edition: November 2008
Fifth Edition: February 2014
Loadstar Sensors Inc.,
48501 Warm Springs Blvd., Suite 109
Fremont, CA 94539
(510) 623-9600 [Voice]
(510) 623-9602 [Fax]
WARRANTY
The material contained in this document is provided “as is,” and is subject to being changed without
notice. Further, to the maximum extent permitted by applicable law, Loadstar Sensors disclaims all
warranties, either express or implied, with regard to this manual and any information contained herein,
including by not limited to the implied warranties of merchantability and fitness for a particular
purpose. Loadstar Sensors shall not be liable for errors or for incidental or consequential damages in
connection with the furnishing, use, or performance of this document or of any information contained
herein. Should Loadstar Sensors and the user have a separate written agreement with warranty
terms covering the material in this document that conflict with these terms, the warranty terms in the
separate agreement shall override.
SAFETY INFORMATION
General
Do not use this product in any manner not specified by the manufacturer. The protective features of
this product may be impaired if it is used in a manner not specified in the operating instructions.
Do not install substitute parts or perform any unauthorized modification to the product. Return the
product to a Loadstar Sensors office for any required service and repair to ensure that safety features
are maintained.
Instrument Grounding
If your product is provided with a grounding type power plug, the instrument chassis and cover must
be connected to an electrical ground to minimize shock hazard. The ground pin must be firmly
connected to an electrical ground (safety ground) terminal at the power outlet. Any interruption of the
protective (grounding) conductor or disconnection of the protective earth terminal will cause a
potential shock hazard that could result in personal injury.
Cleaning
Clean the outside of the instrument with a soft lint-free, slightly dampened cloth. Do not use detergent
or chemical solvents. Doing so may void your warranty.