Loadstar Sensors DI-1000U Digital Load Cell Interface Manual - Manual (Page 25)

DI-1000 Di1000 User Guide
Page: 25 / 25
P/N : 033-01591 Rev. 6
7 DI-1000 T
ECHNICAL SPECIFICATIONS
Performance
Resolution See Figure 10: Typical noise free equivalent resolution (bits)
Output Resolution Dynamic, Sensor Dependent
Update Speed Programmable, 7.5 – 3840 Samples/Second
Output Sensitivity Sensor dependent
Software Filter None
Temp Coefficient None
Environment
Operating Temperature -10 to 55C (15 to 131F) (no battery)
-10 to 45C (15 to 113F) (with internal battery)
Storage Temperature -20 to 85C (-5 to 185F) (no battery)
-20 to 60C (-5 to 140F) (with internal battery)
Warning: NEVER EXCEED 60C when internal battery is installed
Humidity 5 to 85% RH Non Condensing
Voltage 6 to 12 VDC [Basic Edition], 6 to 32 VDC [Battery Edition]
Power 1 W
Vibration Not to exceed 4 mm displacement at 16.7 Hz, for > 60 mins.
Shock Not greater than a 20 cm drop onto a hard wooden surface
Enclosure
Construction Material ABS Plastic
Dimensions approx. 3.2” x 1.6”
Maximum Remote Load Cell Cable Length
Cable Length 100 feet, 20 Gauge wire (6 wire sensor)
Cable Length 20 feet, 20 Gauge wire (4-wire sensor)
Special Interfaces
Host Interface USB (virtual COM)
Sensor Interface USB host