Loadstar Sensors DQ-4000 - Manual (Page 17)

DQ-4000 DQ-4000 User's Guide
Page: 17 / 21
P/N : 033-02061 Rev. 1
4.4 O0W0 and O0W1 Commands
Function: Output the gross load for the currently selected channel
Summary: These commands output the load of the currently selected channel(s).The load
is relative to the gross tare set by previous CT0 or CT1 command. The data is
output in a single column: Computed load (millipounds).
O0W0 outputs the data continuously, while O0W1 outputs it once. The
streaming data generated by an O0W0 can be stopped by pressing [Enter].
Example: O0W0 (Starts streaming computed load from currently selected channel)
4.5 O0X0 & O0X1 Commands
Function: Output the gross load for all 4 channels + the total
Summary: These commands output loads (in millipounds) for each channel as well as for
the sum of all four channels. These loads are relative to the gross tare set by the
previous CT0 or CT1 command. The data is output in 5 columns: each column is
the computed load for its respective channel. Column 5 contains the sum of all
channels. Any disconnected channel is displayed as 0 millipounds.
O0X0 outputs the data continuously, while O0X1 outputs it once. The streaming
data generated by an O0X0 can be stopped by pressing [Enter].
Example: O0X0 (Starts streaming computed load from all channels)
4.6 O0T0 & O0T1 Commands
Function: Output the gross load for all 4 channels + the total
Summary: These commands output load relative to the gross tare set by the previous CT0
or CT1 command. The data is output in 2 columns: a millisecond timer and the
computed load (millipounds) of the currently selected channel(s).
O0T0 outputs the data continuously, while O0T1 outputs it once. The streaming
data generated by an O0T0 can be stopped by pressing [Enter].
Example: O0T0 (Starts streaming millisecond timer and computed load from the currently
selected channel(s)).