Beko WMA 727 S - Manual (Page 23)

EN 23
Program in rinse hold mode
• This process is shown with the
flashing Spin Symbol (Figure 3-13c)
and the lit up Standby Symbol
(Figure 3-13k).
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button (Figure 2-10).
The program continues, pumps out
the water and spins. Standby Symbol
(Figure 3-13k) fades out and Start
Symbol (Figure 3-13j) lights up.
If you want to discharge the water only
without spinning:
Press “Start/Pause/Cancel” button
(Figure 2-10). Standby symbol (Figure
3-13k) will fade. Start symbol (Figure
3-13j) will light up. The program
continues and only pumps out the
water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End” label will appear on the screen.