MARVEL Scientific 6FAR - Manual (Page 4)

MARVEL COMMERCIAL
INSTALLATION:
Select Location
The proper location will ensure peak performance of your
appliance. Choose a location where the unit will be out of
direct sunlight and away from heat sources.
Do not install the unit where the temperature will go below
60
°F, because it will not run often enough to maintain
proper temperatures.
Do install it on a floor strong enough to support a fully
loaded unit.
Cabinet Clearance
Ventilation is required from the bottom front section of the
unit. Keep this area open and clear of any obstructions.
Units with fan cooled condensers can be built in. The adja-
cent cabinets and countertop can be built around the unit
as long as no top trim or countertop is installed lower than
the top of the hinge.
Leveling Legs
(If supplied) Adjustable legs at the front corners of the unit
should be set so the unit is firmly positioned on the floor
and the front is raised just enough so the door closes easily
when opened about halfway.
Turn leveling legs clockwise to raise unit, counterclockwise
to lower it.
Electrical Connection
Check serial plate for correct power supply. Use only elec-
trical power supply as specified on your appliance serial
nameplate. DO NOT USE AN EXTENSION CORD.
Grounding Method
This product is factory equipped with a power supply cord
that has a three-pronged, grounded plug. It must be
plugged into a mating grounding type receptacle in ac-
cordance with the National Electrical Code and applicable
local codes and ordinances (see Figure 1). If the circuit
does not have a grounding type receptacle, it is the re-
sponsibility and obligation of the customer to exchange the
existing receptacle in accordance with the National Electri-
cal Code and applicable local codes and ordinances. The
third ground prong should not, under any circumstances,
be cut or removed. All U.L. listed refrigerated products are
equipped with this type of plug.
3
Figure 1
Power supply cord
with 3 - prong
grounding plug.
Grounding type
wall receptacle