MARVEL Scientific 6FAR - Manual (Page 7)

6
THINGS TO REMEMBER:
Allow 24 hours for your unit to reach a new tempera- 1.
ture setting.
The motor will start and stop often. It must do this to
2.
maintain the temperature you select.
Keep your unit reasonably level.
3.
Unplug the unit before working on anything with the 4.
electrical system.
Exercise caution when sweeping, vacuuming, or mop-
5.
ping near the front of the unit. Damage to the grille
and / or the light fixtures switch can occur.
For all cleaning of the unit, mix 2 tablespoons of bak-
6.
ing soda with 1 quart of warm water. Do not use strong
cleaners or scouring powder or pads.
Keep all flame or sparks away from flammable mate-
7.
rial storage refrigerators when opening the door to
remove or store commodities.
Disconnect electrical power before removing F.M.S.
8.
refrigerator electrical plug.
CARE AND CLEANING:
Condenser
The condenser tubing under the cabinet for forced air units
does not require frequent cleaning; however, satisfactory
cooling depends on adequate ventilation over the condens-
er. Be sure nothing obstructs the required air flow openings
in the lower front of the cabinet. At least once or twice a
year, brush or vacuum lint and dirt from the condenser for
efficient performance by unplugging the power cord from
the wall receptacle and unscrewing the grille on the bottom
front of the cabinet. Static condenser units with exposed
coils on the back of the unit should be inspected periodi-
cally and cleaned as required.
Cabinet
The painted cabinet can be washed with mild soap and
water and thoroughly rinsed with clear water. NEVER use
abrasive scouring cleaners.
Interior and Door Gasket
Wash interior compartment with mild soap and water. A
mixture of 2 tablespoons baking soda to 1 quart of water
may be used. Do NOT use an abrasive cleaner, solvent,
polish cleaner or undiluted detergent.
MARVEL COMMERCIAL