MARVEL Scientific 8CRF - Manual (Page 6)

HANDLE INSTALLATION AND DOOR ALIGNMENT PROCEDURE
Figure 6
Door should be
parallel to top
and sides of
refrigerator.
9/32”
(7.1mm)
Door Alignment Procedure
The door should be parallel to the sides and top of the refrig-
erator. If alignment is necessary the door may be adjusted
by loosening the 2 screws which secure the hinge adapter
brackets on the top and bottom of the door and adjusting the
door side to side. Use a 5/32” allen wrench for this procedure.
(See Figure 6 below). When finished aligning the door, tighten
the screws securely.
NOTE
Hinge Color Door Color Right Hand Left Hand
Chrome Black 42247595 42247599
Chrome White 42247639 42247640
Black Black 42247596 42247600
White White 42247597 42247601
Stainless
Steel
Stainless
Steel
42247598 42247602
Door Reversal
It is possible to reverse the door (change from right hand swing
to left hand swing or vice versa) if you wish. To do so it will be
necessary to order one of the service kits below.
Screws
Handle
Figure 5
Right hand hinged
door shown
Handle Installation (Solid Door Models)
1. Remove the handle, (2) screws, and 5/32” hex key wrench
from the bag shipped inside the cabinet.
2. Locate handle opposite the hinges and secure in place using
the (2) screws and the hex key wrench. (See Figure 5).
6
For the door to close properly, it is necessary to maintain a
minimum space of 9/32” (7mm) between the door and cabinet
flange (See Figure 6). This space can be adjusted by adjusting the
top and bottom hinge adapter brackets.
Hinge adapter bracket lo-
cated on the top and bottom
of the door.
Remove top
hinge pin to re-
move the door.