MARVEL Scientific 25CM - Manual (Page 14)

Condenser Air Flow
The condenser underneath the cabinet does not re-
quire frequent cleaning; however, satisfactory cooling de-
pends on adequate ventilation over this heat exchanger.
It is recommended to annually clean the condenser by
vacuuming and brushing. To access the condenser, the
unit must be pulled out from the installation, and the
lower machine compartment access cover removed.
Disconnect the power cord before cleaning the condenser.
Be sure that nothing obstructs the required air flow openings
in front of the cabinet. At least once or twice a year, brush or
vacuum lint and dirt from the front grille area (see page 4).
Cabinet
The painted cabinet can be washed with either a mild soap and
water and thoroughly rinsed with clear water. NEVER use abra-
sive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do NOT
use an abrasive cleaner, solvent, polish cleaner or undiluted
detergent.
Care of Unit
1. Avoid leaning on the door, you may bend the door hinges or
tip the unit.
2. Exercise caution when sweeping, vacuuming or mopping
near the front of the unit. Damage to the grille can occur.
3. Periodically clean the interior of the unit as needed.
4. Periodically check and/or clean the front grille as needed.
CARE AND CLEANING
Defrosting Instructions 15CM and 25CM
1. Push the rocker switch located in the front grille to the
“OFF” position.
2. Remove the ice bucket and place a towel in the lower front
area of the ice maker to absorb the defrost water.
3. After defrosting is completed replace the ice bucket and
press the rocker switch to the “ON” position.
Defrosting Instructions 15CAF
1. Disconnect the power cord and set the temperature control
to the off position. (See page 8).
2. Remove the contents from the freezer.
3. Place pans of hot water in the freezer if you wish to speed
up defrosting.
4. When defrosting is complete wipe out the interior and
replace the contents.
5. Connect power cord to outlet.
6. Set the temperature control to the desired level.
Do not use an ice pick, knife, or any type of sharp object to
remove the ice. Doing so may puncture the units refrigerant
system and damage it beyond repair. You may speed up defrost-
ing by filling the ice bucket with hot water and placing it back
into position.
14