Mayline File Harbor Cabinet Wire Dividers - Manual

Kwik-File, LLC
File Harbor Cabinet
Wire Dividers
MWD: A package of 4 Wire Dividers to be suspended from:
MS48: 42"shelf to fit 48" wide Cabinet
MS42: 36 3/4" shelf to fit 42" wide Cabinet
MS36: 30 3/4" shelf to fit 36" wide Cabinet
NO Tools Required:
1. Remove packaging material. NOTE: Check for concealed damage. Report any damage to
carrier.
2. Wire Dividers are used to separate 3-ring binders, books, etc., which rest on the shelves. The
Wire Dividers must be suspended from another shelf directly above the binders. If the binders will
be on the top shelf of the cabinet, another shelf for suspending the wire dividers must be placed
above them at the very top of the cabinet.
3. If storing binders, you will need 13 slots of vertical space for the binders and the shelf supporting
the binders, and one additional slot for the shelf above (from which the Wire Dividers hang).
4. Before attempting to install the Wire Dividers, first install both the shelf above and below the
binder storage area.
5. Squeeze the front and
back of the Wire Divider together slightly so that it
fits between the front and back lips of the shelf
above.
6. To position the Wire Divider exactly as desired,
slide it sideways, squeezing the front and back
together if necessary.
7. Once the Wire Divider is positioned properly,
spread it apart so that the rubber tipped ends are
forced all the way into the front and back lips of
the shelf above.
8. To re-position a Wire Divider, squeeze the
front and back ends together so that the rubber
tipped ends come out of the shelf lips, then move
it as desired.