Mayline File Harbor Cabinet Wire Dividers - Manual (Page 2)

Kwik-File, LLC
File Harbor Cabinet
Hanger Bar
MHB48:
42" Hanger Bar for 48" wide Cabinet
MHB42: 36 3/4" Hanger Bar for 42" wide Cabinet
MHB36: 30 3/4" Hanger Bar for 36" wide Cabinet
NO Tools Required:
1. Remove packaging material. NOTE: Check for concealed damage. Report any damage to carrier.
2. Remove the 4 shelf clips from the plastic bag taped to the bar.
3. See the attached Configuration Guide for the recommended spacing between the Hanger Bar and
other components. Make sure you know which media the hanger bar is intended to support (tape
seal, print-outs, etc.), and how much space the media will take below the hanger bar, and above the
next compontent. (As an example, 13 slots are required for both the Hanger Bar and a 10 1/2" tape
seal).
4. Put the shelf clips (small tips with flat ends are inserted
upwards - ) in the proper slots in the inside
end panels.
5. showing schematic of Hanger Bars.
6. Install the left support rail on the shelf clips.
7. With the right end of the Hanger Bar tipped upwards (to provide
clearance between the bar and the right inside
end panel of the cabinet), insert the left end of
the bar into the tabs on the left rail, with the
lower side of the bar facing the front of the
cabinet, as shown in Drawing B.
8. With the right end of the bar still tipped
upwards, connect the right rail to the bar by
inserting the right rail tabs into the slots in the
right end of the bar.
9. Ease the right side of the Hanger Bar
assembly down onto the shelf clips so that it is
firmly in place.
Back
Front