MBT Lighting CX1603 - Manual (Page 4)

10
12. CROSS button
Press this button to enter or leave CROSS mode in chase mode and when CROSS ON indicator is lit.
13. PATTERN + button
Press to increase the left two digits by one . Pressing this button for more than one second increases the digits
quickly from present counter till the maximum and then increase from the minimum cyclically.
SHIFT + BUTTON SETUP
Pressing SHIFT + BUTTON SETUP together sets the channel fader ; LATCH button and FLASH button,
each pressing makes a new setting , and the matching indicator is lit.
14. PATTERN-button
Press to decrease the left two digits by one. Pressing this button for more than one second decreases the
digits quickly from present counter till the minimum and then decrease the digits quickly from present
counter till the maximum an then decrease from the maximum cyclically.
SHIFT + FADE TIME SETUP
Pressing SHIFT + FADE TIME SETUP sets the fade time. When NO FADE TIME indicator is lit. fade time
is disabled . If STEP TIME indicator is lit, fade time is set by the SPEED knob and is identical to the step
time.
15. STEP + button
Press to increase the right two digits by one. Pressing this button for more than one second increases the
digits quickly from present counter till the maximum and then increase from the minimum cyclically. In
chase mode, press this button to execute the pattern by one step. Pressing for more than one seconds allows
to execute the pattern by ten steps per second.
SHIFT + CROSS SETUP button
Pressing SHIFT + CROSS SETUP together sets ENABLE or DISABLE for CROSS mode. If CROSS OFF
indicator is lit, Press the CROSS button to enter or leave CROSS mode.
16. STEP-button
Press to decrease the right two digits by one. Pressing this button for more than one second decreases the
digits quickly from present counter till the minimum and then decrease from the maximum cyclically. In
chase mode, press this button to execute the pattern by one step. Pressing for more than one seconds allows
to execute the pattern by ten steps per second.
SHIFT + BLIND button
Pressing SHIFT+BLIND together sets ENABLE or DISABLE for BLIND mode. When it is BLIND mode,
the ENABLE indicator is it.
17. ADD/KILL button
Press to select ADD or KILL mode and if it is KILL mode the indicator near this button is lit. In ADD mode,
the FLASH button levels are isolate from other levels. In KILL mode and when the FLASH button levels are
turned on, the other levels are set to zero.
18. PROGRAM button
Press this button for more than one seconds to enter PROGRAM mode. the indicator close to this button is lit,
now 30 variable patterns(1~30) are ready to be programmed, each containing 99 steps at most. Press this
button to store your setting as one step. the LCD shows the next step to be programmed.
SHIFT + END STEP button
IN PROGRAM mode, pressing SHIFT + END STEP together stets the present step as the last step
19. ASSIGN button
Press this button for more than one seconds to enter ASSIGN mode. the indicator close to it is lit .In ASSIGN