MBT Lighting CX1603 - Manual (Page 8)

10
2. FULL ON button
Press this button down, channel 1 to channel 8 are full on and not controlled by STAND BY.
3. STEP UP button
In CHASE mode, press to execute the pattern by one step, pressing for more than one second would execute the
pattern by 10 steps per second.
4. PATTERN UP button
In CHASE mode, press to select pattern by plus one, press for more than one seconds would increase the pattern
quickly till the maximum and then increase from 01.
5. CONTROL OUTPUT cable
Connect to the FOOT CONTROL located on the rear of DM-16
PIN FUNCTION
1 STEP UP
2 PATTERN UP
3 STAND BY
4 FULL ON
5 COMMON
MIDI SETTING
1. NOTE DATA
NOTE NUMBER VELOCITY FUNCTION
22-81 master level for the pattern turn on/off 1-60 patterns
82-97 channel dimmer identical to that set by FLASH 1-16
99 FULL ON
101 execute the pattern by one step
102 change the ATAND YB status
2. If MIDI signal disappears, 10 minutes latter the matching indicator is off and the MIDI settings are
dumped.
3. To receive MIDI signal. set the MIDI channel according to the setting of MIDI controller.
4. The patterns turned on by MIDI are not controlled by LEVEL knob and not showed in the LCD. all
turned on patterns are executed synchronously and the terminal level is synthesized by the levels of the
turned on patterns.
OPERATING INSTRUCTIONS
1. RUN PATTERN
Ⅰ、 Press appropriate function button(s) to select desired chasing mode from AUTO, MANUAL. AUDIO and
TAP SYNC, the LCD shows the pattern and the step.
Ⅱ、 Press PATTERN + or PATTERN-to select desired pattern from 30 built-in patterns(31-60) and 30 variable
patterns(1-30).(If the right two digits show 00, the pattern is blank or had been deleted.)
2. PROGRAM
Press PROGRAM button for more than one seconds to enter PROGRAM mode, the matching indicator is lit.
Press PATTERN+ to select desired pattern, Make a setting by means of fader 1 to fader 8 and LATCH button
and press PROGRAM button once to store the setting as a new step. Make anew setting and press RPGOARM
once again. If you have entered all steps press SHIFT + ENDSTEP button together to define the last step.