Baby Einstein 30886 - Manual (Page 2)

– 2 –
The base frame
assembly is complete.
Set it aside for use in
a later step.
2 Assemble the seat frame.
A Locate the footrest wire frame with connecting hubs.
Place it on a flat surface with the toy bar sockets pointing
upward as shown.
B Locate the backrest wire. Position it so that the wire ends
are near the connecting hubs.
C Partially insert both left and right ends of the backrest
wire into the corresponding sockets in the connecting
hubs. (Stop just before either spring-loaded button enters
the hub.)
NOTE: To avoid binding, do not fully insert one wire end
before inserting the other end.
D Press the spring-
loaded button on the
left end of the backrest
wire and fully insert it
into the connecting
hub. Verify that the
button fully engages,
latching the wire frame
to the hub.
E Repeat Step D for the right end of the backrest wire.
Sockets
pointing upward
Footrest wire frame
Backrest wire frame
Connecting
hub
Connecting
hub
3 Connect the seat frame to the base frame.
A Hold the seat frame in
position above the base
frame. Prepare for
assembly by verifying that:
• the toy bar sockets on
the connecting hub
point upward, and...
• the wire ends on the
base frame point toward
the corresponding holes
in the connecting hubs.
B Partially insert both left and
right ends of the base
frame wire into the holes in
the connecting hubs. (Stop
just before either spring-
loaded button enters the
hub.)
C Press the spring-loaded
button on the left end of the
backrest wire and fully
insert the wire into the
connecting hub. Verify that
the button fully engages,
locking the wire frame into
the hub.
D Repeat Step C for the right
end of the base frame wire.
E Inspect both connecting
hubs to verify that the
frame wires are fully
inserted. Be sure that the two spring-loaded buttons at
each hub have fully engaged.
The bouncer frame assembly is complete.
4 Attach the seat pad to the seat frame.
CAUTION: Adjust the wiring as needed to keep it away
from the U-shaped recess in the frame. Otherwise, the
vibration unit may crimp the wiring.
Sockets pointing
upward
Connecting hub
Spring-loaded buttons
Incorrect Correct