Boss Audio Systems Boss Loop Station RC-300 - Manual (Page 24)

Phrase Memory Settings
24
Parameter Value Explanation
Assign1 Src Mode
MOMENT
Specifying the Type of Operation (Source Mode)
If a momentary-type foot switch (such as the separately sold FS-5U) is connected as the source, you can specify how
foot switch operations will affect the value.
* If the [LOOP FX] pedal is set to MOMENT, it will no longer be possible to enter Pedal Function mode (p. 10) by
holding down the [LOOP FX] pedal for two seconds or longer.
MOMENT
The setting will normally be off (minimum value); it will be on (maximum value) only while
you continue holding down the foot switch.
TOGGLE
The setting will alternate between off (minimum value) and on (maximum value) each time
you press the foot switch.
Default assignments of functions controlled
The default assignments are as follows. If you simply connect pedals without making any settings, you can use them to control the following
parameters and functions.
Assign Switch Assign Source Assign Target Explanation
Assign1 ON EXP1 PEDAL EFFECT CONTROL
The effect that’s most suitable for the selected LOOP FX type will be
applied.
Assign2 ON EXP2 PEDAL Level The pedal will control the volume of the phrase memory.
Assign3 ON CTL1 PEDAL MEMORY INC
The pedals will switch phrase memories.
Assign4 ON CTL2 PEDAL MEMORY DEC
Assign5 ON CTL3 PEDAL FX TYPE INC
The pedals will switch the LOOP FX type.
Assign6 ON CTL4 PEDAL FX TYPE DEC
Assign7 ON SYNC START/STOP ALL PLAY/STOP
All tracks can be simultaneously played/stopped upon reception of
ALL START/STOP messages from the master RC-300 unit (p. 39).
Assign8 OFF
POLARITY switch
When Connecting EV-5s When Connecting FS-5Us When Connecting FS-6s
Connecting to External Pedals
Connect your EXP pedals (EV-5 , etc. ; available separately) or foot switches (FS-5U, FS-6; available separately) as shown in the illustration.
The function of the external pedal (EXP pedal or foot switch) can be assigned independently for each phrase memory. For details, refer to “Assigning
the Function of Pedals and External Controllers (Assign)” (p. 23).
Red
CTL 4 CTL 4 CTL 2 EXP 3 CTL 2 CTL 3 CTL 3 CTL 1 EXP 2 CTL 1
Red White White
Cable:
Stereo 1/4” phone
type fg
1/4” phone type x 2
MODE/POLARITY switch
Cable:
Stereo 1/4” phone
type fg
Stereo 1/4” phone type
* Use only the specified expression pedal (Roland
EV-5, etc. ; sold separately). By connecting
any other expression pedals, you risk causing
malfunction and/or damage to the unit.
* If you use a mono cable to connect a single FS-5U, the CTL 1, 2 jack will be CTL 1, and the CTL 3, 4 jack will be CTL 3.