MitxPC VoomPC-2 - Manual (Page 3)

3) Connect the Front Audio header (marked “AUDIO”) to the motherboard’s Front Audio
header using the 2x5 shielded cable. NOTE: You need to remove the 2 jumpers from the
Motherboard’s Front Audio header.
4) Connect the Front USB header (marked “USB”) to the motherboard’s internal USB
header.
5) Connect the LED header to the Motherboard’s LED header. If using M1-ATX or M2-
ATX power supplies you might want to connect this LED to the power supply LED
header. (The M1/M2-ATX provides additional visual information (blinks) reporting various
states of the system)
6) Connect the Fan-In header to the motherboard’s fan header. Connect the Fan1 and
Fan2 headers to the front fans.
7) Install the HDD and CDROM (optional) into the metal bracket and connect to the
motherboard using the IDE cable.
8) Install the motherboard I/O shield at the back of the VoomPC-2 enclosures
Figure 1.1, bottom mounting plate
9) Your final assembly should look similar to Figure 1.1. Slide the bottom plate into the
extrusion and stop half way into the slide. Connect the power input faston wires to the
Power Supply unit. (In case you are using a Power Amplifier, connect the AMP RMT
wires to the Power Supply Anti-Thump header.
VoomPC-2 Installation Guide Page 3