MitxPC VoomPC-2 User Manual
Page 4
10) Hook up Monitor, Keyboard, etc and test your system by turning ignition ON.
11) Secure the VoomPC-2 using the 4 front/back mounting screws. If you don’t want to
drill holes into your car chassis, stick large Velcro pads to the bottom plate of the
VoomPC-2 (the hook side) and attach to your car’s carpet and a strong adhesion will be
formed.
4.0 Power Connector Wiring Diagram
Figure 1.3, power connector diagram
Connector type is Molex “mini-fit JR” series, 2 x 4 configuration. Co
for additional information on housings and mating pins (male/female). All “mini-fit JR”
parts can be purchased on-line from www.digi-key.com.
NOTE: The Black and Green wire harness labeled “not connected” is intended to special
projects use. For example, should you need additional 5V or 12V output, you could take
advantage of this pre-installed wires.
5.0 Mechanical
-Dimensions: 210(W)x265(L)x66(H)mm
-Weight, including packaging: 3.0Kg
6.0 Support and warranty
Standard Hardware Warranty 1Year / US, 2 Year EU
VoomPC-2 Installation Guide Page 4