MK Diamond MK-4000 Series - Manual (Page 21)

21
MK-4000 SERIES OPERATION
WARNING
Observe the rotation arrow on blade and DO NOT exceed maximum RPM stamped on the blade. To
set proper RPM, consult the Blade Guards and Blade Sizes Table on page 16.
6. Tighten the arbor bolt.
7. install the blade guard in place. Make sure that the guard locks in place and connect the hose.
NOTICE
To meet ANSi safety standards, larger diameter blade flanges are required for large diameter blades.
information is available upon request or for complete safety information refer to ANSi Safety Code B7.1
NOTICE
We recommend the use of MK diamond blades with this saw.
BLADE MOUNTING INSTRUCTIONS CONTINUED
Tighten Arbor Bolt Install Blade Guard