MK Diamond MK-4000 Series - Manual (Page 9)

9
• ALWAYS use caution when handling fuel. Shut off the engine and allow to cool before refueling.
The MK-4000 is equipped with a number of safety decals provided for operator safety and mainte-
nance information. Should any of these decals become unreadable, replacements can be obtained by
calling (800) 262-1575.
MK-4000 Safety Decal Sheet, Part No. 166009
OPERATION & SAFETY DECALS
MK-4000 SERIES SAFETY
Decal C
Decal D, E & G
Decal F
Decal A Decal B
Decal H
Decal J Decal I
Read entire operatorʼs manual before operating this
machine. Understand all warnings, instructions and
controls. IF YOU DO NOT HAVE AN OPERATORʼS
MANUAL, CALL TOLL FREE 1-800-474-5594
Machinery Hazard - Always keep all guards in place
and in good condition. Always keep all parts of your
body away from blade and all other moving parts.
Never allow blade exposure to exceed 180°.
Always use blades with a rated speed above the
blade shaft speed. Excessive speed can cause blade
breakage. Verify speed by checking blade shaft RPM,
pulley diameters and blade flange diameter.
Never use damaged
blades or equipment.
Never operate this machine
in areas of combustible material.
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities
contains chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and
cement and other masonry products
• Arsenic and chromium
from chemically-treated lumber
Always wear safety approved hearing,
eye, head and respiratory protection
WARNING
DANGER
Lethal exhaust
gases. Use only
in well ventilated
areas. DO NOT
use indoors.
CAUTION
Keep
hands and
feet clear.
!
Decal B
NOTICE
Overtensioning of belts
will result in premature
crank and/or bearing failure.
!