MK Diamond 24" Cutting Kit - Manual (Page 2)

24 Inch Cutting Kit Revision 02/01, Effective Date February 7, 2001 Page 2
24-INCH CUTTING KIT (Document Part Number 158364)
Cutting Head With Threaded Pivot Shaft:
NOTE: Found on older models
Cutting Head Without Threaded Pivot Shaft:
(A)
Install the Shaft Extension
into the threaded end of the
Cutting Head Pivot Shaft
(B)
Remove the Cutting Head
Pivot Shaft from the Post
(C)
Grease the square indentation
end of the Replacement Shaft
(A)
Loosen the Cutting Head Pivot
Shaft retaining screw
(E)
Tighten the Cutting Head Pivot
Shaft retaining screw
(D)
Install the square indentation
end of the Replacement Shaft
into the Post
Removal
Direction
Rotate clockwise
to install
Shaft
Extension
3/8-Inch
Allen Wrench
Rotate counter-
clockwise to loosen
Shaft Retaining
Screw Post
Pivot
Shaft
Replacement
Shaft
Square Indentation
Facing Retaining Screw
Installation
Direction
Shaft Retaining
Screw
3/8-Inch
Allen Wrench
Rotate clockwise
to tighten
Shaft Retaining
Screw