MK Diamond ATS Stand - Manual (Page 19)

ATS Stand (ATS Stand Part No. – 156426) Revision 04/01, Effective Date: April 11, 2001 Page 19
ATS STAND (Document Part Number 158474)
MK-2000 Series:
To ensure stability, verify front and rear legs of the ATS Stand are fully extended outward before
installing the saw.
NOTE: The following Brackets are required for fastening the saw to the ATS Stand -
(F)
Verify the rear bracket is
installed correctly
4
D Brackets
(B)
Remove the Cutting Table
(See the saw Owners Manual)
(C)
Verify ATS Stand legs are
fully extended for stability
(A)
Remove Water Pan
(E)
Install the Bracket A and a Bolt
into the top, rear, of the ATS
Stand as shown
(D)
Seat saw on the ATS
Stand as shown
(H)
Install one D Bracket and a Bolt
into the front, side, of the ATS
Stand as shown
(G)
Install one D Bracket and a Bolt
into the rear, side, of the ATS
Stand as shown
Removal
Direction
(I)
Verify the two right-side D
Brackets are installed correctly
Remove
Cutting Table
Extend legs
outward
Back of saw
Back of ATS Stand
Bracket
A
Bracket
D
Install into front hole
on right side of stand
Install into rear hole on
the right side of stand
1
A Bracket
Bracket
A
Fit bracket
over saw frame
Bracket
D
Install into rear hole
on right side of stand
Fit bracket
over saw frame
Bracket
D