MK Diamond ATS Stand - Manual (Page 5)

ATS Stand (ATS Stand Part No. – 156426) Revision 04/01, Effective Date: April 11, 2001 Page 5
ATS STAND (Document Part Number 158474)
MK-100, 101, and 101 Pro Normal Cutting Head Position Installation:
To ensure stability, verify front and rear legs of the ATS Stand are fully extended outward before
installing the saw.
NOTE: The following Brackets are required for fastening the saw to the ATS Stand -
(B)
Remove the Cutting Head
(See the saw Owners Manual)
(C)
Verify ATS Stand legs are
fully extended for stability
(A)
Remove Water Pan
(E)
Install the Bracket A and a Bolt
into the top, rear, of the ATS
Stand as shown
(F)
Install one C Bracket and a Bolt
into the top, rear, of the ATS
Stand as shown
(D)
Seat the saw on the ATS
Stand as shown
(H)
Install one B Bracket and a Bolt
into the front, side, of the ATS
Stand as shown
(G)
Verify the rear brackets are
installed correctly
Removal
Direction
Install into rear hole
on right side of stand
(I)
Install one B Bracket and a Bolt
into the rear, side, of the ATS
Stand as shown
Remove
Cutting Head
Extend legs
outward
Back of saw
Back of ATS Stand
Bracket
A
Install into rear hole
on left side of stand
Bracket
C
Fit bracket
over saw frame
Bracket
C
Bracket
A
Fit bracket
over saw frame
Bracket
B
Install into front hole
on left side of stand
Bracket
B
Fit bracket
over saw frame
Install into middle hole
on left side of stand
2
C Brackets
2
B Brackets
1
A Bracket