MK Diamond MK-S - Manual (Page 16)

16
Slide the pivot bar into clamp.
Adjust to proper radius.
The Vacuum Pivot Kit (part #168186) is used for radius and circular cutting. The kit consists of one
base, one vacuum pump, one air hose and four pivot bars.
VacUUM KiT
Place the three bolts into
center pivot mounting bracket
and screw into to saw
Place base on clean, flat
surface and attach air hose
to base by pulling back collar
and sliding onto coupling.
Place the clamp on the center
screw.
Screw pivot bar into center
pivot mounting bracket on
saw.
Add additional pivot bars to increase radius of cut. noTE:
MK-S oPEraTionS
For PErFEcT circLES anD arcS
Set up vacuum base and
mark cut with soap stone by
rotating pivot bar
Attach saw to pivot
bar
Adjust depth of cut
and begin cutting