MK Diamond TX-3 Manufacturer Water Pump - Manual (Page 2)

6. Cooling Flow: Maintenance/Troubleshooting:
Verify the cooling flow by
ensuring Adjusting Clamp is
open. Remove the Cooling
Transfer Tube from the coupling.
Place Pump into a bucket of
water and check flow.
Remove the Cooling Transfer
Tube and check for flow.
Remove the Pump Discharge
Fitting and check for flow.
Remove the Pump Intake
Screen and check for debris–
clean the screen if necessary.
Remove the 3 Pump Casing
Retaining Screws.
Remove the Pump Casing and
check for restriction in the
casing. Check the Impeller for
damage.
© 2010 MK Diamond Products, Inc. All Rights Reserved. Images and specifications are subject to change without notice. Part # 164800-IS (03/10)
1315 Storm Parkway, Torrance, CA 90501 | P 800.421.5830 | www.mkdiamond.com | F 310.539.5158
Remove the Drain Plug from
the water pan.
Place the Water Pump in an
external container. Fill the external
container until water completely
covers the Water Pump suction.
4. External Water Source:
Place an external catch basin
below the water pan drain hole.