MK Diamond Canoga 193 Gas - Manual (Page 26)

26
193 SERIES CONCRETE MIXER MIXER MAINTENANCE
Wheel Lug Nuts Tightening Sequence Torque Wrench
NOTICE NEVER use an pneumatic air gun to tighten wheel lug nuts.
Pneumatic Air Gun
1
2
3
4
5
Lug Nut Torque Requirements
Mixer Storage
It is extremely important to apply and maintain proper wheel mounting torque on the trailer. Be sure
to use only the fasteners matched to the cone angle of the wheel. Proper procedure for attachment of
the wheels is as follows:
For storage of the mixer for over 30 days, the following is recommended:
Start all wheel lug nuts by hand using a Torque Wrench.
Torque all lug nuts in sequence. DO NOT torque the wheel lug nuts all the way down.
Tighten each lug nut in 3 separate passes as defined by Troubleshooting table. After first road use,
retorque all lug nuts in sequence. Check all wheel lug nuts periodically.
Drain the fuel tank completely, or add STA-BIL to the fuel.
Run the engine until the fuel is completely consumed.
Completely drain used oil from the engine crankcase and fill with fresh clean oil, then follow the
procedures described in the engine manual for engine storage.
Clean the entire mixer and engine compartment.
Place the mixing drum in the down position (mouth facing downward).
Cover the mixer and place it a clean dry area, that is protected from harsh elements.