MMF POS Advantage Series Cash Drawer (C1 Body Size) 18.8 x 20 - Manual (Page 5)

Advantage User Manual
Last revised: 9/1/2012
4
Upgradeable Interface Connections
USB with Statistics Interface
The USB Interface has been designed to interface with any standard
Universal Serial Bus (USB) 2.1 or 1.1 Type A Port.
 The MMF POS USB Interface Board is factory defaulted to recognize the cash drawer
as drawer number zero (0) or seven(7), the dip-switch pins need to be configured to
recognize the Drawer to number (1), refer to USB Interface Manual for Dip-Switch
Position (Default Setting) or follow the pin configuration illustrated in the label attached
to the interface for correct pin orientation.
 Connect the power supply by plugging the small plug tip to the interface recepticle in the
back of the cash drawer. Plug the power adapter end into a 120 Volt AC Recepticle.
 The utility drivers, test utility, and User Manual for the USB Interface can be found
online at: www.mmfpos.com > Software Drivers
USB with Statistics & 4-Port USB Hub Combo Interface
The MMF USB Hub feature offers the end user the capability to link an array of USB
devices via the four (4) USB ports within the cash drawer interface. This solution will
increase your connectivity potential and accessibility.
 USB 2.0 & 1.1 compliant
 Plug & Play and hot swappable capability
 System Requirements: PC - Pentium 233 and Higher, 1 USB 2.0 port, WIN
98SE/ME/2000/XP
 6 ft. USB 2.0 A-B cable
Follow the procedures detailed in the USB with Statistics & 4-Port USB Hub Combo User Manual which came
with the cash drawer or could be downloaded from www.mmfpos.com .
Warning! Make all electrical
connections to the cash
drawer with the computer’s
power turned off.
Warning!
Do not assign
two (2) USB
interface cash
drawers
within the
same system
with the same
cash drawer
number.