MTS SWIFT 50 GLP Sensor - Manual (Page 57)

Road and Track Vehicles
SWIFT 50 GLP Sensors Installation Installing the Transducer 57
Collecting Data
After you zero the TI, you are ready to collect data.
Note If you turn off power to the TI boxes, the zero values will remain valid, but
the encoder will need to find the index pulse to properly convert the
rotating coordinates to stationary coordinates. The transducer outputs
will not be correct until this happens.
To reset the encoder, roll the vehicle either forward or backward so that
the tire completes at least one revolution. This can be accomplished
while driving to the test area, or if the vehicle is on a lift in the garage
area, rotate the tire according to the guidelines in
, “Considerations for
rotating a tire,” on page 45.
1. Spin the wheel twice to ensure that the encoder tick is correct.
Spinning the wheel after you have completed the zero process will ensure
that the encoder is correctly referenced to the index pulse. Otherwise, the
data collected during the first revolution will be flawed.
2. Remove the vehicle from the lift or jacks.
3. Secure the connector that attaches the signal cable to the top of the slip ring
with high quality duct or electrical tape.
This will prevent dust, dirt, and water from entering the connector and
causing wear on the pins and sockets.
4. Verify that the shunt contacts are covered.
Make sure that the covers on the shunt connectors are in place and that the
thumb screws are tight.
5. Perform a final inspection of the SWIFT sensor and the electronics to ensure
that everything is secure and the TI is on.
The zero data is saved at the end of each completed procedure. If the TI is
off, the zero data will not be lost. However, due to thermal conditions that
could affect your data, if the TI is powered off for an extended period of
time (such as over night), you must repeat the zero process.
Note Rezeroing the transducer is good practice when thermal changes occur.
Rezeroing the transducer at conditions and temperatures closest to the
test conditions will provide a more accurate zero and reduce thermal
errors.
6. Turn on the data recorder.
7. Start data collection.
Important Before beginning data collection, read the cautions on the
next page.