Beko 2012 CX - Manual (Page 5)

EN
5
Warnings |
• This product is designed for household
usage.
• Your washing machine is adjusted to
230 volts. Your machine may not
operate with low voltage.
• If the current value of the fuse at your
home is less then 16 amperes, consult
a qualified electrician and have a fuse of
16 amperes installed.
• When using with or without a
transformer, make sure that the
grounding installation is made by a quali-
fied electrician. When used without
grounding, our company shall not be
responsible for the possible damages.
• In order to make your machine ready to
use, call Authorized Service and if your
clean water installation and water drains
are not proper, call a qualified plumber.
• Your machine should not be placed on
a rug covered floor. Otherwise, electrical
parts may overheat since your machine
will not be able to take air from the
bottom. This may lead to the machine
malfunction.
• While installing the machine, make sure
that the hot and cold water taps are
connected correctly. Otherwise, your
laundries may come out hot in the end
of washing process and worn out.
• When the supply cord/plug of the
machine is damaged, you must call the
authorized service.
• Make sure that the water inlet hoses are
new. Do not use worn out/used water
inlet hoses again. It may cause stains to
remain on your laundries.
• Before washing the clothes that are pre-
treated with cleaning agents (gasoline
ether, liquid stain remover and etc.) rinse
thoroughly with clean water.
• Never wash the device with a water
hose! There is a risk of electric shock!
Before cleaning, always disconnect the
electricity connection by unplugging.
• Never touch the plug with wet hands.
Never grab from the cable but from the
plug when unplugging.
• If the power cable or the plug is
damaged, or the appliance shows any
other errors, do not operate the
appliance!
• For the failures that can not be solved by
applying the information given in these
operating instructions:
Turn off the machine, unplug it, close
the water tap and contact with the cus-
tomer service center. Never try to repair
the machine by yourself.
• When you operate your washing ma-
chine for the first time, use Cotton 90o
program with detergent without loading
the machine with laundry in order to
make it ready for washing your laundry.
After washing the very dirty clothes such
as the working clothes of a car techni-
cian, it is recommended to repeat the
machine cleaning process.
• The performance of your washing
machine depends on the compound
effect of the machine, water and the
cleaning agent that is used. If poor
and unqualified cleaning agents are
used, stains on your laundries will be
stabilized. Before washing the stained
laundries, pay attention to clean them as
described in the following pages.
• Your machine is designed to resume
its operation when the power restores
after a power failure. You can not cancel
the program by pressing On/Off button.
When the power restores, the machine
will resume from the point it stopped.
• During the production, some water may
have remained in your machine because
of the quality control processes. It does
not cause any damage to your machine.
• Plug must be accessible after
installation.
• The repair or change of main plug
should be carried out by authorized
technicians or specialists.
• Main water pressure should be between
1 - 10 bars.