Beko 2012 CX - Manual (Page 8)

EN
8
Models with double water inlets can be
used as a model with a single water inlet
by using a plug. Plug should be installed
to the hot water valve. A rubber gasket
should be used in order to prevent water
leakage from the connection point.
Do not connect the product with single
water inlet to the hot water tap. The prod-
uct may switch to the protection mode if
the temperature of the water connected to
a product with double water inlet through
a Y part and single water inlet is above
40°C.
a) Water drainage hose
Water drainage hose can be attached to
the side wall of a sink or bathtub. Hose
should not be bend. When the drainage
hose is hanged on a sink or bathtub, it can
be secured with a hose bracket so that it
will not fall.
The end of drainage hose can be
connected directly to the waste water
drainage hole or to the specific end that is
installed to the outlet elbow of the sink.
The hose should be installed to a height
of 40 cm minimum and 100 cm maximum.
Water connections
a) Water inlet hose
The specific hoses that come with the
machine are connected to the water inlet
valves on the machine. Red labeled hose
is for hot water inlet and blue labeled hose
is for cold water inlet.
"If you are going to use your double water-
inlet machine as a single (cold) water-inlet
unit, you must install the stopper*, sup-
plied with your machine to the hot water
valve.
If you want to use both water inlets of the
product, you can connect the hot water
hose after removing the stopper and gas-
ket group from the hot water valve.
* Applies for the products supplied with a
blind stopper group. "
Since the connection points are under
water pressure, turn on the taps to the
maximum after the connection. Check if
there is any water leakage at the connec-
tion points. In order to prevent the water
leakages and the damages they may
cause, keep the taps closed when you are
not using the machine.
Minimum 1 bar and maximum 10 bars of
water flow from the tap is enough for your
machine to operate efficiently. (In practice,
1 bar means that more than 8 liters of wa-
ter per minute flows from a full open tap.)
Install the elbowed end of the hose to your
machine. Hand-tighten the nuts of the
hose, do not use a spanner
0
10
20
30
40
50
60
70
80
90
100
110