Blaupunkt MEMPHIS MP66 7 646 520 310 - Manual (Page 46)

Changing basic settings in the settings menu
110
Selecting a sound preset
( Presets)
This menu item allows you to se-
lect one of the following sound
presets: Vocal, Disco, Rock, Jazz,
or Classic.
Press the softkey located next
to the desired sound preset.
: The sound preset is se-
lected.
: The sound preset is not
selected.
Setting the speed-dependent
volume increase ( Auto Sound)
When you are driving faster, the
device can automatically increase
the volume to compensate for the
driving noise. In order for this to
work, the speedometer signal
must be connected as described
in the installation instructions.
You can adjust this volume in-
crease from 0 (no increase) to 5
(maximum increase).
Press the softkey 9 (next to
"Auto Sound").
The "Auto Sound" menu appears.
Note:
If no increase is set, the display
shows "AUTO SND OFF".
➔
•
•
➔
On the rocker switch 3 , press
or to raise the volume in-
crease.
On the rocker switch 3 , press
or to lower the volume in-
crease.
Setting the bass increase
( X-Bass)
X-bass is a bass increase at low
volume. This bass increase can be
set in increments from 0 (no in-
crease) to 6 (maximum increase)
for the following frequencies: 32 Hz,
40 Hz, 50 Hz, 63 Hz, or 80 Hz.
Press the softkey ;
(next to "X-Bass").
The individual frequencies are
displayed as bars and the bass
increase as bar segment.
On the rocker switch 3 , press
or to select the desired fre-
quency.
On the rocker switch 3 , press
or to set the desired bass
increase.
Switching off the equalizer
Press the softkey : in the
"Digital Equalizer" menu
(next to "Off").
➔
➔
➔
➔
➔
➔
02_BA_Memphis_EU_eng.indd Menü110 02_BA_Memphis_EU_eng.indd Menü110 03.05.2006 10:44:10 Uhr 03.05.2006 10:44:10 Uhr